2-pair DIN rail plug-in Data surge protector
DLA2-06DBC
DLA2-06DBC
Part Number: 640131
  • Din rail plug-in surge protector
  • 2-pair
  • Un: 6 V
  • Shield wire protection
  • Without line cut-off
  • IEC 61643-21 compliance
  • UL497A
Installation Sheet

DLA2 surge protectors are designed to protect, against surge voltages due to lightning, terminals equipment connected to industrial buses, telecom lines or datalines. These surge protectors must be installed on symmetrical DIN rail and are available for most of the transmission lines: line voltage from 6 to 170V, bitrate up to 10 Mbit/s. These products are 2-pair surge protectors with removable module for easy maintenance.



Network
MIC/T2, 10BaseT
Nominal line voltage
6 V
Max. DC operating voltage
8 V
Max. load current
300 mA
Max. frequency
> 20 MHz
Insertion loss
< 1 dB
Max. discharge current
max. withstand @ 8/20 µs by pole
20 kA
Line inductance
No
Protection mode(s)
Common/Differential mode
Protection level
Following the test category C3 (IEC61643-21) - Line/Line
25 V
Max. shunt capacitance < 50 pF
Impulse current
2 x 10/350µs Test - D1 Category
5 kA
Nominal discharge current
8/20µs Test x 10 - C2 Category
5 kA
Line/Line Nominal discharge current
8/20µs Test x 10 - C2 Category
5 kA
Line/Ground Nominal discharge current
8/20µs Test x 10 - C2 Category
5 kA
Line resistance
< 4.7 Ohm
Technology GDT+Clamping diode
SPD configuration 2-pair + shielded
Connection to Network screw terminal - cross section 0.4-1.5 mm²
Format
Plug-in DIN box
Mounting
Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Short-circuit - transmision cut-off - fault mode 2
Disconnection indicator Transmission interrupt
Spare module(s)
DLA2M-06dBC
Remote signaling of disconnection
no
Dimensions
See diagram
Certification
UL listed
Standards compliance
IEC 61643-21 / EN 61643-21 / UL497A