Type 2 (or 3) AC surge protector - 3-phase
DS13-230
DS13-230
Part Number: 341503
  • Type 2 (or 3) AC Multipolar surge protector
  • In : 5 kA
  • Imax total: 30 kA
  • Pluggable module by phase
  • Remote signaling option
  • EN 61643-11, CEI 61643-11, UL1449 ed.4 compliance
Installation Sheet

DS10 type2 AC surge protector are used mainly for primary protection of single and 3- phase networks at the main electrical panel. They provide common-mode or common and differential mode. This SPD is based on high energy varistor equipped with thermal disconnector and failure indicator, to comply with standards.

The DS10 surge protectors are designed to be used in a multipolar configuration to protect single-phase, 3-phase or 3-phase+Neutral AC networks.They are sometimes associated with dedicated N/PE surge protector based on gas tube technology.



SPD type
following IEC test
2 (ou 3)
Network
230/400 V 3-phase
AC system
TNC
Nominal line voltage
230 Vac
Max. AC operating voltage L-N
255 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Residual Current
Leakage current to Ground
< 1.5 mA
Operating current
Continious current at Uc
0.5 mA
Follow current
None
Nominal discharge current
15 x 8/20 µs impulses
5 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
10 kA
Total Maximal discharge current
max. total withstand @ 8/20 µs
30 kA
Withstand on Combinaison waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
10 kV
Withstand on overvoltages IEEE C62.41.1
10 kV
Admissible short-circuit current
25000 A
Connection mode(s)
L/PE
Protection mode(s)
Common mode
Protection level L/PE
@ In (8/20µs)
0.9 kV
Technology MOV
SPD configuration 3-phase
Connection to Network By screw terminals: 2.5-25 mm² / by bus
Format
Plug-in modular box
Mounting
Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection
Disconnection indicator 1 mechanical indicator by pole
Spare module(s)
DSM10-230
Remote signaling of disconnection
option DS13S-230 : output on changeover contact
Dimensions
See diagram
Certification
EAC
Standards compliance
IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Installation ground fault breaker Type 'S' or delayed
Thermal disconnector Internal
Fuses
Fuses type gG - 20A