Surge protector for LED lighting system Class 1
MLPC1-230L-R
MLPC1-230L-R
Part Number: 831211
  • Type 2 (or 3) surge protectors for LED
  • Class 1
  • Very compact
  • Plate mounting
  • Spring terminal connection
  • Status indicator
  • Disconnection AC end of life
  • EN 61643-11 compliance
Installation Sheet

The MLPC range is a comprehensive series of AC surge protectors dedicated to LED lighting system. The MLPC are very compact to be integrated into luminaires and are available 2 modes of connection (screw terminal or spring).



SPD type
following IEC test
2+3
Network
220-240 V single-phase
AC system
TT/TN
Nominal line voltage
230-277 Vac
Max. AC operating voltage L-N
320 Vac
Max. load current
5 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Temporary Over Voltage N/PE (TOV HT)
without disconnection or with safety disconnection
1200 V/300A/200 ms disconnection
Residual Current
Leakage current to Ground
None
Nominal discharge current
15 x 8/20 µs impulses
5 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
10 kA
Total lightning current
max. total withstand @ 10/350µs
20 kA
Withstand on Combinaison waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
10 kV / 5 kA
Withstand on overvoltages IEEE C62.41.1
10 kV / 10 kA
Admissible short-circuit current
10000 A
Protection mode(s)
Common/Differential mode
Protection level
@ In (8/20µs)
1.5 kV
Protection level L/N
@ In (8/20µs)
1.5 kV
Protection level L/PE
@ In (8/20µs)
1.5 kV
Protection level CM/DM
@ In (8/20µs)
1.5 kV/ 1.5 kV
Technology MOV+GDT
Connection to Network 2 spring terminals opposite side in/out - wire 1.5 mm² max.
Mounting
On plate
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection and AC line cut-off
Disconnection indicator Led green OFF and AC network cut-off
Voltage/operating indicator Green Led ON
Dimensions
See diagram
Standards compliance
EN 61643-11 / IEC 61643-11
Certification
EAC / TUV /IMQ
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed