Surge protectors for LED lighting system Class 2
MLP2-230S-P
MLP2-230S-P
Part Number: 721202
  • Type 2 or 3 surge protector
  • For LED lighting system
  • Class II
  • Very compact dimensions
  • Max. discharge current 10kA
  • EN 61643-11, IEC 61643-11 compliance
Installation Sheet

The MLP range is a comprehensive series of AC surge protectors dedicated to LED lighting system. Some versions are equipped with an extra dataline surge protection (RS485 or DALI) in order to provide a full solution for LED systems with transmission features. By this way the MLP range is able to provide all the existing configurations with an efficient solution . MLP surge protectors are based on a powerful association of MOV and GDT components, able to protect LED system against huge surges without disconnection. In the worse case, the SPD will fail in safety condition. Indication of the SPD failure is performed through power supply cut off and/or through remote signaling feature.



SPD type
following IEC test
2+3
Network
220-240 V single-phase
AC system
TT-TN
Nominal line voltage
220-240 Vac
Max. AC operating voltage L-N
305 Vac
Max. load current
2.5 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Residual Current
Leakage current to Ground
None
Follow current
None
Nominal discharge current
15 x 8/20 µs impulses
5 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
10 kA
Total lightning current
max. total withstand @ 10/350µs
20 kA
Withstand on Combinaison waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
10 kV / 5 kA
Withstand on overvoltages IEEE C62.41.1
10 kV / 10 kA
Admissible short-circuit current
10000 A
Protection mode(s)
Differential Mode
Protection level
@ In (8/20µs)
1.5 kV
Protection level L/N
@ In (8/20µs)
1.5 kV
Protection level L/PE
@ In (8/20µs)
1.5 kV
Protection level CM/DM
@ In (8/20µs)
1.5 kV
Technology MOV+GDT
Connection to Network screw 1.5mm² max
Mounting
On plate
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection and AC continuity
Disconnection indicator Green Led off and remote signaling
Voltage/operating indicator Green Led ON
Remote signaling of disconnection
yes : output on contact NO
Dimensions
See diagram
Standards compliance
IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed