Surge protectors for LED lighting system Class 2
DSLP2-230L
DSLP2-230L
Part Number: 352933
  • Type 2 (or 3) surge protectors for LED
  • Very compact (low profile)
  • DIN rail mounting
  • Screw terminal connection
  • Status indicator
  • Disconnection AC end of life
  • EN 61643-11 compliance

DSLP range is an AC series surge protectors for DIN mountage create to protect LED systems. The surge protectors DSLP are verry compact to be integrated in the luminaires and are available in 2 connection modes (terminal screw or spring).



SPD type
following IEC test
2
Network
220-240V single-phase
AC system
TT/TN
Nominal line voltage
230-277 Vac
Max. AC operating voltage L-N 320 Vac
Max. load current
10 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Residual Current
Leakage current to Ground
None
Nominal discharge current
15 x 8/20 µs impulses
5 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
10 kA
Total lightning current
max. total withstand @ 10/350µs
20 kA
Withstand on Combinaison waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
10 kV / 5 kA
Withstand on overvoltages IEEE C62.41.1 10 kV / 10 kA
Admissible short-circuit current 10000 A
Protection mode(s)
Differential Mode
Protection level
@ In (8/20µs)
1.5 kV
Protection level L/N
@ In (8/20µs)
1.5 kV
Protection level CM/DM
@ In (8/20µs)
1.5 kV
 
Technology MOV
Connection to Network Screw terminal 2.5 mm² max.
Mounting Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection
Disconnection indicator Led green OFF and AC network cut-off
Voltage/operating indicator Green Led ON
Dimensions
See diagram
Standards compliance EN 61643-11 / IEC 61643-11
Certification EAC
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed