Surge protector for LED lighting system Class 1
DSLP1-120L/Y
DSLP1-120L/Y
Part Number: 352922
  • Type 2 (or 3) surge protectors for LED
  • Very compact (low profile)
  • DIN rail mounting
  • Screw terminal connection
  • Status indicator
  • Disconnection AC end of life
  • EN 61643-11 compliance
CITEL_Certif_EAC_AC_PV.pdf Installation Sheet
Contact Us
DSLP range is an AC series surge protectors for DIN mountage create to protect LED systems. The surge protectors DSLP are verry compact to be integrated in the luminaires and are available in 2 connection modes (terminal screw or spring).
SPD type 2 (ou 3)
Network 120 V single-phase or 2-phase
AC system TN
Nominal line voltage Un 120 Vac
Max. AC operating voltage L-N Uc 150 Vac
Max. load current IL 10 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 120 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 230 Vac disconnection
Residual Current Ipe None
Nominal discharge current In 5 kA
Max. discharge current Imax 10 kA
Total Maximal discharge current Imax Total 20 kA
Withstand on Combination waveform IEC 61643-11 Uoc 10 kV / 5 kA
Withstand on overvoltages IEEE C62.41.1 10 kV / 10 kA
Protection mode(s) Common/Differential mode
Protection level Up 1.5 kV
Protection level L/N Up L/N 1.5 kV
Protection level L/PE Up L/PE 1.5 kV
Protection level CM/DM Up mc/md 0.7 kV / 0.7 kV
Admissible short-circuit current Isccr 10 000 A
Technology MOV+GDT
Connection to Network Screw terminal 2.5 mm² max. Earthing conductor 2 mm² - length 60 cm
Mounting Symmetrical rail 35 mm (DIN 60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe mode Disconnection
Disconnection indicator Led green OFF and AC network cut-off
Voltage/operating indicator Green Led ON
Dimensions See diagram
Standards compliance EN 61643-11 / IEC 61643-11
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed