Type 1+2 AC surge protector single-phase
DS252E-300/G
Part Number: 3404
- Type 1 + 2 unipolar surge protector
- Iimp total: 50 kA (10/350µs импульс)
- Imax : 140 kA (8/20µs импульс)
- Внутренний размыкатель сети, индикатор состояния
- Дистанционная сигнализация
- Соответствуют IEC 61643-11, EN 61643-11 и UL1449 ed.4
Datasheet
The DS250E is an extreme duty Type 1+2 designed to protect the entrance of the electrical installation.
They are used to protect biphase, 3-phase or 3-phase + neutral networks in common mode or in common and differential mode.
The 'Multi-Varistor' technology used allows the best possible behavior for the LV network (no follow-on current).
The DS250E is mounted on a DIN Rail and has a double connection for the active conductor, which allows an optimized connection to the network.
Select another reference:
| SPD type | 1+2 | |
| Network | 230 V single-phase | |
| AC system | TT-TN | |
| Nominal line voltage | Un | 230/400 Vac |
| Max. AC operating voltage | Uc | 330 Vac |
| Max. load current | IL | 100 A |
| Temporary Over Voltage (TOV) Charasteristics - 5 sec. | UT | 335 Vac withstand |
| Temporary Over Voltage (TOV) Charasteristics - 120 mn | UT | 440 Vac disconnection |
| Temporary Over Voltage N/PE (TOV HT) | UT | 1200 V/300A/200 ms withstand |
| Residual Current | Ipe | None |
| Follow current | If | None |
| Nominal discharge current | In | 70 kA |
| Max. discharge current | Imax | 140 kA |
| Impulse current by pole | Iimp | 25 kA |
| Total lightning current | Itotal | 50 kA |
| Specific energy by pole | W/R | 156 kJ/ohm |
| Connection mode(s) | L/N and N/PE | |
| Protection mode(s) | Common/Differential mode | |
| Protection level L/N | Up L/N | 2.5 kV |
| Admissible short-circuit current | Isccr | 50000 A |
| Technology | MOV | |
| SPD configuration | Single phase | |
| Connection to Network | By screw terminals : 6-35 mm² / by bus | |
| Format | 1-pole modular box assembled | |
| Mounting | Symmetrical rail 35 mm (DIN 60715) | |
| Housing material | Thermoplastic UL94 V-0 | |
| Operating temperature | Tu | -40/+85°C |
| Protection rating | IP20 | |
| Failsafe mode | Disconnection | |
| Disconnection indicator | 3 mechanical indicators by pole | |
| Remote signaling of disconnection | Output on changeover contact | |
| Dimensions | See diagram |
| Standards compliance | IEC 61643-11 / EN 61643-11 / UL1449 4ed. | |
| Certification | EAC |
| Thermal disconnector | Internal | |
| Installation ground fault breaker | Type 'S' or delayed | |
| Fuses | Fuses type gG - 315 A |
