Type 1+2 AC surge protector - 1-pole
DS131R-230
DS131R-230
Part Number: 571501
  • Type 1 + 2 AC surge protector
  • In : 20 kA
  • Iimp : 12,5 kA
  • Pluggable module for each phase
  • Remote signaling (option)
  • EN 61643-11, IEC 61643-11 and UL1449 4ed. compliance
Installation Sheet

The DS130R is an extreme duty Type 1+2 designed to protect the entrance of the electrical installation. The DS130R is a one-pole SPD and can be used in common mode or common and differential mode.

DS130R AC surge protectors are designed to be connected in multi-pole configuration to protect single-phase, 3-phase and 3-phase+neutral AC networks.

This SPD is DIN rail compatible.



SPD type
following IEC test
1+2
Network
230/400 V
Nominal line voltage
230 Vac
Max. AC operating voltage L-N
255 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Operating current
Continious current at Uc
< 1 mA
Follow current
None
Nominal discharge current
15 x 8/20 µs impulses
20 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
50 kA
Impulse current by pole
max. withstand 10/350µs by pole
12.5 kA
Withstand on overvoltages IEEE C62.41.1
20 kV
Admissible short-circuit current
25000 A
Connection mode(s)
L/N or N/PE
Protection mode(s)
Common Mode or Differential Mode
Protection level
@ In (8/20µs)
1.3 kV
Specific energy by pole
max. withstand 10/350 µs
40 kJ/ohm
Technology MOV
SPD configuration 1-pole
Connection to Network By screw terminals: 2.5-25 mm² / by bus
Format
Plug-in modular box
Mounting
Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection
Disconnection indicator 1 mechanical indicator
Spare module(s)
DSM130R-230
Remote signaling of disconnection
option DS131RS-230 : output on changeover contact
Dimensions
See diagram
Certification
EAC
Standards compliance
IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Installation ground fault breaker Type 'S' or delayed
Thermal disconnector Internal
Fuses
Fuses Type gG - 125 A