Type 2 AC surge protector - one-phase - pluggable
DS41S-120
DS41S-120
Part Number: 331611
  • Type 2 AC surge protector
  • In : 20 kA
  • Imax : 40 kA
  • Pluggable module for each phase
  • Remote signaling
  • NF EN 61643-11, CEI 61643-11 compliance
  • UL1449 ed.3

used mainly for primary protection of single and 3- phase networks at the main electrical panel. They provide common-mode or common and differential mode. This SPD is based on high energy varistor equipped with thermal disconnector and failure indicator, to comply with standards.

The DS40 surge protectors are designed to be used in a multipolar configuration to protect single-phase, 3-phase or 3-phase+Neutral AC networks.They are sometimes associated with dedicated N/PE surge protector based on gas tube technology.


Select another reference:

SPD type
following IEC test
2
Network
120/208 V
Nominal line voltage
120 Vac
Max. AC operating voltage L-N 150 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
180 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
230 Vac disconnection
Residual Current
Leakage current to Ground
< 0.5 mA
Operating current
Continious current at Uc
0.5 mA
Follow current
None
Nominal discharge current
15 x 8/20 µs impulses
20 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
40 kA
Admissible short-circuit current 25000 A
Connection mode(s)
L/N or N/PE
Protection mode(s)
Common Mode or Differential Mode
Protection level
@ In (8/20µs)
0.9 kV
Residual voltage at 10 kA
@ 8/20µs
0.7 kV
Residuel voltage at 5 kA
@ 8/20µs
0.6 kV
 
Technology MOV
SPD configuration 1-pole
Connection to Network By screw terminals: 2.5-25 mm² / by bus
Format Plug-in modular box
Mounting Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Failsafe behavior Disconnection
Disconnection indicator 1 mechanical indicator
Spare module(s)
DSM40-120
Remote signaling of disconnection Output on changeover contact
Dimensions
See diagram
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Certification EAC
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed
Fuses
Fuses type gG - 50 A